Supero SUPER P6SLA, User'S And Bios Manual

Page: 23 / 91

SUPER P6SLA/P6SLE User’s Manual
1-14
face to a PCI bus operating at 33 MHz. This interface implemen-
tation is compliant with the PCI Rev 2.1 Specification. The AGP
interface is based on the AGP Specification Rev 1.0. It can
support up to 133 MHz (532 MB/s) data transfer rates.
1-5 Wake-On-LAN (WOL)
Wake-on-LAN is defined as the ability of a management applica-
tion to remotely power up a computer which is powered off.
Remote PC setup, updates, and asset tracking can occur after
hours and on weekends so daily LAN traffic is kept to a minimum
and users are not interrupted.
The motherboard has a 3-pin header (WOL) used to connect to
the 3-pin header on the Network Interface Card (NIC) which has
WOL capability.
1-6 Power Supply
As with all computer products, a stable power source is neces-
sary for proper and reliable operation. It is even more important
for high CPU clock rates like 333, 300, 266, 233 MHz Pentium II
processors.
SUPER P6SLA/P6SLE accommodates ATX power supplies.
Although most power supplies generally meet the specifications
required by the CPU, some power supplies are not adequate.
It is highly recommended that you use a high quality power
supply. Additionally, in areas where noisy power transmission is
present, you may choose to install a line filter to separate noise
from the computer. You can also install a power surge protector
to help avoid problems caused by power surges.
1-7 Super I/O
The disk drive adapter functions of Super I/O chip W83977TF
(P6SLA) / SMCW602 (P6SLE) include a floppy disk drive controller
compatible with the industry standard 82077/765, data separator,
write pre-compensation circuit, decode logic, data rate selection,
clock generator, drive interface control logic, and interrupt and
DMA logic. The wide range of functions integrated onto the Super