Supero SUPER P6SLA, User'S And Bios Manual

Page: 69 / 91

BIOS User's Manual
5-14
Hard Disk Timeout (Minutes)
This option specifies the length of a period of hard disk drive
inactivity. When this length of time expires, the computer enters
power-conserving state specified in the Hard Disk Power Down
Mode option. The settings are Disabled and 1 Min through 15 Min
in 1 minute intervals.
Standby/Suspend Timer Unit
This allows you to set the standby time out and suspend time out
timer unit. The settings are 32 secs, 4 msecs, 4 min or 4 secs.
Standby Time Out
This option specifies the length of a period of system inactivity
while in full power on state. When this length of time expires, the
computer enters standby power state. The settings are Disabled
and 4 Min through 508 Min in 4 minute intervals.
Suspend Timeout (Minutes)
This option specifies the length of a period of system inactivity
while in standby state. When this length of time expires, the
computer enters suspend power state. The settings are Disabled
and 4 Min through 508 Min in 4 minute intervals.
Slow Clock Ratio
The value of the slow clock ratio indicates the percentage of time
the STPCLK# signal is asserted while in the thermal throttle
mode. The settings are Disabled, 12.5%, 25%, 37.5%, 50%,
62.5%, 75%, and 87.5%.
Display Activity
This option specifies if AMIBIOS is to monitor display activity for
power conservation purposes. When this option is set to Monitor
and there is no display activity for the length of time specified in
the Standby Timeout (Minute) option, the computer enters a power
savings state. The settings are Monitor or Ignore.
Device 6 (Serial port 1)
Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary Master IDE)
Device 1 (Primary Slave IDE)
Device 2 (Secondary Master IDE)