Supero SUPER P6SLA, User'S And Bios Manual

Page: 74 / 91

Chapter 5: Running Setup
5-19
Parallel Port Mode
This option specifies the parallel port mode. The settings are
Normal, Bi-Dir, EPP or ECP. When set to Normal, the normal
parallel port mode is used. Use Bi-Dir to support bidirectional
transfers. Use EPP (Enhanced Parallel Port) to provide asymmet-
ric bidirectional data transfer driven by the host device. Use ECP
(Extended Capabilities Port) to achieve data transfer rates of up to
2.5 Mbps. ECP uses the DMA protocol and provides symmetric
bidirectional communication.
EPP Version
The settings are 1.7 or 1.9. Note: The Optimal and Fail-Safe
default settings are N/A.
Parallel Port IRQ
This option specifies the IRQ to be used by the parallel port. The
settings are Auto, 5 or 7.
Parallel Port DMA Channel
This option is only available if the setting of the parallel port mode
option is ECP. The settings are 0, 1, 2, 3, 5, 6 or 7. Note: The
Optimal and Fail-Safe default settings are N/A.
OnBoard IDE
This option specifies the onboard IDE controller channels to be
used. The settings are Disabled, Primary, Secondary, or Both.
OnBoard NAT307 Mode Set
The settings for this option are Non-PnP and PnP.
OnBoard SCSI
Enable the OnBoard SCSI feature to use the onboard SCSI on the
motherboard. The settings are Disabled or Enabled. Note: The
Optimal and Fail-Safe default settings are N/A.
Remote Power On
Microsoft's Memphis OS supports this feature which can wake-up
the system from SoftOff state through devices (such as an exter-
nal modem) that are connected to COM1 or COM2. The settings
are Disabled or Enabled.
AC Power Lost Restart: Disabled
The settings for this option are Disabled.