Supero SUPER P6SLA, User'S And Bios Manual

Page: 42 / 91

2-17
Chapter 2: Installation
DIMM
Figure 2-7. Installing/Removing a DIMM Memory Module
To Remove:
Use your thumb to gently push the edge of
the socket and release the module. Do this
on both sides for each module.
To Install:
Insert
vertically,
press down
until it snaps
into place.
Pay attention
to the two
notches.
2-7 Connecting Parallel, Floppy and Hard Disk
Drives
Use the following information to connect the floppy and hard disk
drive cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two
connectors to provide for two floppy disk drives. The connector
with twisted wires always connects to drive A, and the connec-
tor that does not have the twisted wires always connects to
drive B.
• An IDE hard disk drive requires a data ribbon cable with 40
wires, and a SCSI hard disk drive requires a SCSI ribbon cable
with 50 wires. A wide SCSI hard disk drive requires a SCSI
ribbon cable with 68 wires.
• A single IDE hard disk drive cable has two connectors to
provide for two drives. To select an IDE disk drive as C, you
would normally set the drive select jumper on the drive to DS1
(or Master). To select an IDE disk drive as D, you would
normally set the drive select jumper on the drive to DS2 (or
Slave). Consult the documentation that came with your disk
drive for details on actual jumper locations and settings.
• A single SCSI ribbon cable typically has three connectors to
provide for two hard disk drives and the SCSI adapter. (Note: