Studer OnAir 1500, Operating Instructions Manual

Page: 193 / 386

OnAir 1500 Digital Mixing Console
Operation 5-137
Document generated: 06.08.14 SW V6.0
5.16.1.1 Supported Audio Files
All players/recorders listed above require audio files with the following
properties:
• USB memory device formatted with FAT32 file system (also refer to
chapter 5.16.1.3 ); maximum file size is 4 GB.
• Maximum memory size is 2 TB.
• Wave or broadcast wave format, file extension ‘wav’.
• Linear PCM coding; sampling rate 44.1 or 48 kHz (for recording, the
configured console sampling rate is used); word length is 16 or 24 bit for
playback and 16 bit for recording.
• REC / PLAY connector: Playback in stereo or mono, recording in stereo.
•
MCH I/O
connector: 8 channels in/out.
5.16.1.2 Files and File names
Audio files and their names must meet the following conditions:
Jingle Player Jingle audio files must be located within a root folder named
Jingle
(case-
insensitive). If the system cannot find this folder when the memory device is
connected, it is automatically generated but will be empty.
File names must begin with the character ‘
J
’ followed by a one- or two-digit
number (1-8 or 01-08) signifying the desk key it can be started with. The file
name extension must be
.wav
. The factory default configuration comprises
four desk keys ( JINGLE 1 / 2 , APPLAUSE and BOO ing), as shown below.
Key 1 Key 2 Key 3 Key 4
The jingle tracks must comply with the file requirements indicated above.
Maximum file name length is limited to 60 characters, including the exten-
sion. The corresponding key is illuminated during playback of a jingle.
Examples:
J01
_Logo_1
.wav
is the station logo that is played upon pressing the
JINGLE 1 desk key.
The
J3 applause .wav
file is played upon pressing the
APPLAUSE
desk
key.
Please note:
If two files should be present the names of which both begin
with the same key number (such as
J03
_Applause_44.1k.wav
and
J03 _Applause_48k.wav
), the key assignment is undefined. When
pressing the APPLAUSE desk key any of the two files may be played then.
Track Player Tracks to be played must be located within a root folder named
Music
(case-insensitive). If the system cannot find this folder when the memory
device is connected, it is automatically generated but will be empty. The file
name extension must be
.wav
.
These tracks must comply with the file requirements indicated above. If more
than 64 tracks should be located in this folder, some of them will be ignored.
Maximum file name length is limited to 60 characters, including the exten-
sion.