3-9
P
ROTEGÉ
® 616 I
NSTALLATION AND
M
AINTENANCE
M
ANUAL
, F
EBRUARY
2001
3. Install Protegé Digital
Keysets
Unpack each unit. A complete installation uses all of the
items on the packing list. Report missing or damaged
items to Sprint Products Group for replacement or credit.
3.1 Insert Overlay and Directory Card
1) Write the extension number on the line/feature
key overlay. Place the overlay on the keyset.
2) Place the protective cover on the line/feature
key overlay. Lock the cover in place by insert-
ing the tabs into the keyset slots.
3) Insert the retractable directory card into the
baseplate retaining channel.
3.2 Desk Mounting:
1) Turn the keyset over and place it facedown on
a table. Plug one end of the coiled handset
cord into the jack labeled "Handset." Press the
first two inches of the handset cord into the
notched strain relief channel. See Figure 3-6.
2) Plug one end of the gray line cord into the jack
labeled "Line."
3) Turn the baseplate upside down. Insert the base-
plate hooks into the upper slots of the keyset. The
raised end of the baseplate should face the line
jack at the top of the phone. See Figure 3-7.
4) Rotate the baseplate down. The tab on the
baseplate should contact the lower keyset slot
labeled "Open." Press the baseplate tab until it
snaps into place with an audible click.
5) Turn the keyset and attached baseplate over.
Place it on its designated desk.
6) Plug the free end of the coiled handset cord
into the jack on the handset. Place the handset
in its cradle.
7) Plug the free end of the gray line cord into the
wall-mounted modular jack.
3.3 Wall Mounting
1) Lift the cradle tab and rotate it 180° until it
clicks into the keyset. See Figure 3-8.
2) Turn the keyset over and place it facedown on
a table. Plug one end of the coiled handset
cord into the jack labeled "Handset." Press the
first two inches of the handset cord into the
notched strain relief channel. See Figure 3-6.
3) Thread one end of the gray line cord through a
square hole in the baseplate and plug the cord
into the jack labeled "Line."
4) Turn the baseplate upside down and insert the
baseplate hooks into the lower slots of the key-
set. The raised end of the baseplate should face
the handset jack at the bottom of the phone.
See Figure 3-9.
5) Rotate the baseplate down. The tab on the
baseplate should contact the upper keyset slot
labeled "Open." Press the baseplate tab until it
snaps into place.
6) Align the holes in the baseplate over the studs
of the wall-mounted plate. Press downward
until the baseplate locks into place.
7) Plug the free end of the coiled handset cord
into the jack on the handset. Place the handset
on its cradle.
Figure 3 - 9: For a wall mount, lift the cradle tab and rotate it
180° until it clicks into the keyset. Changing the cradle tab ori-
entation holds the handset in position.
Figure 3 - 10: For a wall mount, turn the baseplate upside down
and insert the baseplate hooks into the lower slots in the keyset.
The raise end of the baseplate should face the handset jack.
