107
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK TMC Mills with ProtoTRAK RMX CNC Safety, Installation, Maintenance, Service & Parts List
7.3
CTS Filter Element Replacement
Steps needed for the replacement of the filter see figure 7.1 for its location:
1.
Turn off system power.
2.
Relieve any system pressure in the filter line.
3.
Drain the filter canister by removing the drain plug. See figure 7.1
4.
Loosen and remove canister using hex nut at the bottom of the canister.
5.
Remove element by pulling downward with a slight twisting motion and either clean or replace
the element. A replacement filter is available from SWI part number 31219.
6.
Check canister O-ring and replace if needed. See figure 7.3
7.
Lube element O-ring with petroleum jelly or light oil and place on post in filter head.
8.
Install canister and tighten to 42
–
50 ft/lbs.
9.
Confirm there are no leaks after powering the system.
Figure 7.3
–
Filter Canister and Element
7.4
CTS Filter Clog Sensor Replacement
Steps needed for the replacement of the sensor see figure 7.1 for location:
1.
Turn off fluid flow and turn off power to the TMC.
2.
Remove Phillips screw holding connector to sensor and remove connector. Loosen the sensor
with a wrench and remove.
3.
Reverse above steps to replace and reconnect the sensor. Sensor is set from the factory and
needs no calibration.
