77
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK TMC Mills with ProtoTRAK RMX CNC Safety, Installation, Maintenance, Service & Parts List
5.1.2.4
Computer Module Replacement
1.
Turn power off to the machine and control. Disconnect TMC from power source.
2.
Start with the power cord in the upper right-hand corner and unplug all the cables connected to
the Computer Module as shown in figure 5.1.2.4.
3.
Remove the Computer Module from the Programming Panel by removing the 6 screws (circled in
figure 5.1.2.4), 3 along the top and three along the bottom of the enclosure.
Figure 5.1.2.4 - Computer Module Replacement
4.
Replace the Computer Module and reinstall.
5.
Replace the cables connected to the Computer Module as shown in figure 5.1.2.4. Each cable is
marked with its location on the enclosure, be sure to double check the correct wiring before
attaching the power cord.
6.
Attach the power cord to the computer module and power up the TMC.
7.
May need to update software, check Service Code 33. See section 4.8 Software Service Codes.
5.1.2.5
TMC Computer Components
TMC Computer Components
Item
P/N
Description
1
31601
TMC PROGRAMMING PANEL (In Pendant)
2
31602
TMC RUN PANEL (In Pendant)
3
29100-1
TMC COMPUTER MODULE (In Electric Box)
