Sony BVH-2000, Operation And Maintenance Manual

Page: 44 / 505

z
o
r-
«
a:
w
0...
o
I" JLUU.II...IJ.Y.J..,UJLI.Li
buttons is
and the system is servo locked while
pressing the button allows
manual to be To release, press the
button again.
Automatic editing:
When one of the
Il\.Tl..'tT;n"r/J:-A.UU.II...IH..a...a..PLJLJ/ ....
JJ.
buttons and the
lamps and the
matic edit to be
Y\o· ...
t-r......
..-v.,.,.rJ
Edits are done on
editing of
basis.
The field of the editing poin ts is
desiznated by the switch on the SY ..80 board.
To the both the and
OUT should be entered.
Even if all the channel preset buttons are set to
the button is still lit and the
edit mode is Press the channel
preset button and the of the channel will
start again.
frame basis. However, in manual
the edit is done on a field
This is a combination button for and
After the data necessary for automatic
editing has been entered by the buttons, if the
edit has not yet the button operates as a
button. the edit has been carried out and
if the next edit data has not been set yet, the button
operates as a button.
After the AUTO button and one of the,
ASSEMBLE, SPOT ERASE buttons have
been and the edit IN and OUT points have
been entered, the is carried out if
the button is
The following four are available:
( l ) Full of the recorder and player:
Pressing the bu tton lam p
lights) of the and pressing the
button allows the to
have full rehearsal
picture and the audio can be checked for the whole
of the edit by the recorder monitor.
of the Player:
After pressing the CONTROL button
lamp of the operated, pressing the
bu tton allows only the Player to be
of the Recorder:
After turning the CONTROL
go of the
button allows
buttons
operated, pressing
the recorder to
point to 1..11
button is pressed keeping the
button ....
.1. .. ,.,..,..,' .....
u.
the part near the
point can be previewed.
The preview time can be set the
on the S'Y..79 board.
to be operated at
be selected by the
above items (1),
the assemble ..editinz mode, back
the to the IN and stops and the
picture can be seen for about 2 seconds.
switch
can
as in the
When the button
@
has been
LJ.1.'l...IL"lL"lJllll::.
this button makes the tape run to the
several seconds - the number of seconds has been set
in advance before the IN and the tape
stops there. Push either of the buttons and
the button at the same time and the tape
will stop at the a set number of seconds
before the entry
button
button
After the buttons are
at pre roll poin L
time can be set in units of one second from
o
to 15 seconds using the switch on the
SY ..79 board.
the switch on the
set to VITC position and the
selector
®
is set to CODE, the
does not work.
point
point
the tape runs and stops
This button is used to set the automatic editing mode.
Pushing this button ON allows