Sony BVH-2000, Operation And Maintenance Manual

Page: 57 / 505

or PLAY mode, an ASSEMBLE edit can be made.
To release, press the button again. In an ASSEMBLE
editing, the video signal and simultaneously the CTL
tape. the ASSEM-
(the lamps light).
Press the buttons for channels not used for editing to
turn them off (lights out). If all of the channel preset
buttons turned OFF, the machine not into
SYNC channels interlocked, it is impossible to
record only one of the two channels. When assembling
only the AUDIO, it is necessary for the VIDEO signal
to have already been recorded the capstan servo
be ON OFF while an ...... ,,,,,..'.'''.-
BLE editing; however, the VIDEO channel cannot be
released while editing because once it has been switched
ON, the state is held.
monitored by the
sound quality is deteriorated, but the recorded signal is
not affected.
• No audio and no video part occurs just behind the
OUT of
INSERT button
Pressing the INSERT button while in the STOP or PLAY
mode allows insert-editing. To release, press the button
again. For insert-editing, the which has
Therefore. the playback picture not
edit IN or OUT points. Even if the
is pressed, each channel preset but-
so press the desired
Each channel can be switched ON OFF while
insert-editing.
• Setting the V /S SIMUL switch (S 1-1) on the LG-02
board on allows both sync and video signals to
@
SPOT ERASE button
This button is used to partially erase the AUDIO
channel.
(
)
If the SPOT ERASE button is pressed while in the
STOP or STANDBY mode, the machine enters the
SPOT ERASE mode. Select the AUDIO channel to
be erased using the channel buttons and
pressed, the signal on
Rotating the takeup reel (right side) by hand to
make the tape run manually to the right and left
several times allows that portion be erased.
another operation button.
Note: Be sure to release the EDIT button during
running the tape.
(2) spot erase
and enter the cut in/cut out points to be erased
with the ENTRY IN/OUT buttons. Press the SPOT
ERASE button and the machine enters the auto
erase mode. Then press AUDIO SPLIT
erased
Press the STOP button. After that, when the
PREVIEW button
@
is pressed, the audio is
muted between out point and no-signal
the suitability of the erased interval.
pushing the EDIT button
@
allows the actual
erase to take place. The AUTO SPOT ERASE
mode is released automatically after the erase.
AUDIO-3, AUDIO-4/SYNC, VIDEO)
When ASSEMBLE-EDITING, INSERT-EDITING or
making a SPOT ERASE, select the desired channel with
these buttons.
AUDIO-2:
AUDIO-3:
cnannet is
selectee.
The AUDIO-2 channel is selected.
The AUDIO-3 channel is selected.
• Turning ON the TC INS INHIBIT
swi tch on the LG-O 2 board
inhibited when the AUDIO-3
channel is in the TIME CODE
input mode.
AUDIO-4/SYNC: The sync channel is selected.
• the
1-1) on the LG-02 board
allows both the sync and video
channels to be selected simul-
taneously,
The
@
EDIT button
This button is used to carry out edits mode.
Manual editing:
of
ERASE
the servo
locked while PLAY mode, pressing the EDIT button
allows manual editing to be performed. To release, press
the button again.
Automatic
ERASE
buttons and the AUTO MODE button are pressed
lamps light) and the ENTRY IN button is pressed (the
lamp lights), pressing the EDIT button allows an automa-
tic edit to be performed.
1-47
z
o
~
0:
W
CL
a