Sony BVH-2000, Operation And Maintenance Manual

Page: 197 / 505

F
iq.
3~64~4.
T-Tension Arm Height Adjustment
Loosen the setscrew.
that the does not curl along timer roller,
adjust the height of T-tension arm by turning the
cap so that the tape touches flange L.
Set the machine in REV
x
1 SHUTTLE mode.
timer roller and curl becomes as small as
possible along T -tension arm.
4. When the mode is changed from F.FWD to REV
SHUTTLE, check that the curl does not
the
SETSCREW
F
ig. 3~64~5.
Ch'lngea.
't'\t:ll'rtf'l.rm
Step
5. Tigh ten the setscrew.
Timer Roller Height Adjustment
Note: The height of the timer roller and T-tension
influences
of
CAP
L
F
ig.
3~64-6.
BVH-2000(U/C)/PS/PM
BVH-2500(U/C)/P
arm also.
1. Check that the screw of flange U is tightened.
2. Loosen the setscrew.
the machine the
that
out curl.
4. Tighten the setscrew and check that the screw of
U is tightened.
Guide Post 1 Height Adjustment
1. Loosen the setscrew.
Set the machine in the REC mode. Adjust the
of the so the
touches flange without curl.
3. Tighten the setscrew.
Note
1.
Do not adjust the guide post 1 unless abso-
after adjusting the height to the value shown
in Fig. 3-63.
3-49
ill
U
z
<t
z
ill
~
Z
<t
~
o(j