Sony BVH-2000, Operation And Maintenance Manual

Page: 29 / 505

®
DISPLAY HOLD button and lamp
If this button is pressed, at any position, the data
displayed on the display
®
is held. At the same time,
the lamp lights up to indicate the DISPLAY HOLD
mode. this button pressed again, lamp goes
off data currently read
SH IFT button/ADVANCE button/R ESET button
Preset the TIMER-I and TIME CODE to the value
desired. Not applicable for TIMER-2. When the
DISPLAY HOLD button
®
is set to ON, the buttons
work as follows.
SHIFT button: Moves the cursor displayed in the
lower part of the display. One
moves the up by
ADVANCE button: the number indicated
the cursor. Each increases
the value by one.
RESET button: After setting all the digits to the
desired value, the PRESET button
inputs them as data.
(I) to TIMER-I
TIME
and hold
to data as The
be done when the TIMER-I is in display
mode (the S9-5 on the SY-80 board is set to ON).
(2) Data input to TIME CODE
Set the TIME CODE/TIMER selector
®
to TIME
CODE. Set the VTR to STOP/STANDBY mode
and hold the display using the DISPLAY HOLD
bu tton . Then the time generator
starting to desired operating
the
the the value
Set
CD
to and the
inpu t from code generator will be dis-
played.
@
STOP button
Pressing the STOP button stops all modes. The reel
motor stops and the pinch roller is retracted from the
tape.
• 30 seconds after the STOP button has
the release mechanism
z
o
r-
<!
II
UJ
CL
o
TENSION
swi tch on the board
turned OFF so that the tension release mechanism
does not operate.
• The macnine goes into the STOP mode automatically
after the power is turned on or if the tape is out of
the tape sensor.
• STOP lamp
being SUIJP1:1ed
STOP
slack
@
STANDBY button
This push on/push off button is used to start the drum
rotating. In normal use, after the STANDBY button
has been pressed, the SERVO alarm lamp
Q)
is checked
to see that it is off and then the desired mode button is
pressed. However, it is also possible to go into that
mode pressing desired button directly without
STANDBY having
the
leJ Jl
j''''.l.'''JLP
the STANDBY mode released automatically.
• If the STANDBY OFF ENABLE switch (S9-8) on
the SY-79 board is OFF, automatic release of the
STANDBY mode does not operate.
• If the tape sticks when the head drum starts to
rotate, the tension release mechanism operates to
slacken the tape.
• STANDBY
@
PLAY button
When the PLAY button is pressed, the PLAY and
STANDBY lamps light and the machine enters the
normal playback mode (normal speed in the forward
direction). To cancell, press the STOP, JOG, SHUTTLE,
V AR or PREROLL button.
• possible to playback
HEAD
CP>IA,("t"Ar
• a compensation of the playback tape
is necessary for synchronizing two BVH series
turn the SEARCH dial
@
clockwise (faster) or
counterclockwise (slower) keeping the PLA Y
button pressed. The degree of compensation is
determined by the rotation angle, and the range is
within ±15% of the normal speed (capstan override
Releasing the PLAY button will
to the speed.