Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
76(113)
4.26.2
Label Installation
Tools needed to perform the following steps:
•
ESD-tweezers
Step-by-Step Instructions
NOTE! This product contains two labels, an
information label and a logo label. Both
labels are printed at the same time on one
label and then that label is separated into
two parts.
NOTE!
Both the information label and the logo label
do not have to be replaced just because one
of the labels requires replacement.
NOTE!
No more than two labels
are allowed
stacked on top of each other in the battery
cavity. If there are already two labels of the
label being replaced present, perform the
label removal procedure before proceeding.
1.
If a new label has not been created yet, then do so at
this time.
2.
Separate the logo label and the information label.
3.
Using tweezers, position the new label(s) that are
being installed in the appropriate location(s) shown.
NOTE! When correctly placed, the information label
should be within the rectangular recessed
area directly adjacent to the battery
connector and the logo label should be
directly above the information label.
4.
Once the label(s) is correctly positioned, carefully
smooth the label(s) into place.
•
Perform sections 2.2.4 – 2.2.5 of the Base Reassembly Procedure
