Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
32(113)
4.3.2
Keypad Installation
If this part is being replaced, a new part should be used in the place of the old part when
performing the following steps.
Tools needed to perform the following steps:
None
Step-by-Step Instructions
1.
Orient the inner base cover so its inner surface is
facing upward and verify that a flip bumper strip is
present between the two screw bosses at the system
connector end of the base cover. If the flip bumper
strip is not present, install one.
2.
Place the keypad, keys down, into the opening in the
inner base cover.
NOTE! The keypad should be oriented so that the
shape of the keypad corresponds to the
shape of the opening in the inner base cover.
•
Perform sections 2.2.1-2.2.5 of the Base Reassembly