Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
41(113)
Step-by-Step Instructions
4.
Using your thumb, apply pressure to the RF port
plug so that outer surface of the RF port plug is
flush with the surrounding surface of the outer base
cover.
NOTE! If the RF port plug was oriented correctly
when installed, the contour of its outer
surface will correspond to the contour of the
outer base cover around it.
•
Perform section 2.2.5 of the Base Reassembly
4.9
Style-Up Cover
The removal and installation of this part is covered in the flip disassembly and reassembly
procedures. To remove this part, perform section 3.1.1 of the flip disassembly. To install this part,
perform section 3.2.3 of the flip reassembly. If this part is being replaced, a new part should be
used in the place of the old part when performing the reassembly instructions.
