Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/597 B
©
Sony Ericsson Mobile Communications AB
53(113)
4.16.2
Flip Screw Cover Installation
When a screw cover is removed, a new screw cover should always be used in the place of it.
Tools needed to perform the following steps:
*
Style 2A ESD tweezers
NOTE! A “ * ” beside a tool listed above indicates that the tool is not specifically called out in the
following instructions, but an operator may find it helpful to use that tool when performing some
steps of the following procedure.
Step-by-Step Instructions
1.
Make sure the phone is open so that the keypad is
accessible.
NOTE! Do not use a previously used screw cover.
NOTE! The screw covers have a specific
orientation. The notch in the screw cover
should be aligned to the standoff in the
screw’s recess hole.
2.
Install a new screw cover over the exposed screw
that is beside the co-brand label area.
3.
Using your thumb, apply pressure to the newly
installed screw cover so that a good bond forms
between the screw cover and the top of the screw.
•
No reassembly required.