SMC Networks 7724M/VSW - annexe 1, Manual

Page: 92 / 387

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 91
The following table lists the sub-commands in the Bitloading per tone command.
Sub-command Description
tx-bit-ne Get Tx Per Tone BitLoading Info Near End
snr-ne Get Rx Per Tone SNR Info Near End
noise-margin-ne Get Rx Per Tone Noise Margin Near End
feq-ne Get Rx Per Tone Current FEQ ine Coeffs Near End
tx-pwr-ne Get Tx Per Tone Tx Power Near End
tx-gi-ne Get Tx Per Tone Gi Near End
qln-ne Get Rx Per Tone Quiet Line Noise Near End
coarse-feq-ne Rx Per Tone Coarse FEQ Near End
block Get Param Block Read Far End (valid for ADSL2/2+/VDSL2 only)
hlog-ne Get Per Tone HLOG Info Near End (valid for ADSL2/2+ only)
hlin-ne Get Per Tone HLIN Info Near End
hlin-scale-ne Get Per Tone HLIN Scale Near End
Tab. 5.8 Sub-commands in Bitloading Per Tone
5.3.2.13 G.handshake Tone
To configure G.handshake tone of each port, use the following command.
Command Mode Description
lre PORTS ghs a43 [ i43 ] [ v43 ]
lre PORTS ghs b43 [ i43] [ v43 ]
lre PORTS ghs none
Bridge
Configures G.hs tone carrier of each port
a43, b43, i43, v43: A43, B43, I43, V43 Carrier Set
none: None G.hs Carrier mode
You can not configure A43 G.hs carrier with B43 at the same time.
To display the G.hs Carrier configuration of each port, use the following command.
Command Mode Description
show lre ghs [ PORTS ]
Enable
Global
Bridge Shows G.hs carrier configuration of each port.
5.3.3 VDSL Checking Errors of VDSL Port
In switch it is possible to check times of error from VDSL port every time interval. More-
over, it is possible to check the error duration time.
Checking Times of Errors
You can check how many times CRC errors, Frame loss and Signal loss are happened.
Error is counted every 15 minutes after booting. After the time is over, the number is reset
to “0” and error is counted again. In addition, error is counted by each day. It is also reset
to “0” after the day. Consequently, you can check times of error (Curr.15m) at present
i