SMC Networks 7724M/VSW - annexe 1, Manual

Page: 166 / 387

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 165
The order of priority is emergency > alert > critical > error > warning > notice > info >
debug . If you set a specific level of syslog output, you will receive only a syslog message
for selected level or higher. If you want receive a syslog message for all the levels, you
need to set the level to
debug .
The following is an example of configuring syslog message to send all logs higher than
notice to remote host 10.1.1.1 and configuring local1.info to transmit to console.
SWITCH(config)# syslog output notice remote 10.1.1.1
SWITCH(config)# syslog output priority local1 info console
SWITCH(config)# show syslog
System logger on running!
info local volatile
info local non-volatile
notice remote 10.1.1.1
local1.info console
SWITCH(config)#
7.5.2 Facility Code
You can set a facility code of the generated syslog message to send them remote syslog
server. This code make a syslog message distinguished from others, so network adminis-
trator can handle various syslog messages efficiently. Facility code is only used with sys-
log messages to send to remote syslog server.
To set a facility code, use the following command.
Command Mode Description
syslog local-code <0-7> Sets a facility code.
no syslog local-code
Global
Deletes a specified facility code.
The following is an example of configuring priority of all syslog messages which is trans-
mitted to remote host 10.1.1.1, as the facility code 0.
SWITCH(config)# syslog output err remote 10.1.1.1
SWITCH(config)# syslog local-code 0
SWITCH(config)# show syslog
System logger on running!
info local volatile
info local non-volatile
err remote 10.1.1.1
local_code 0
SWITCH(config)#
i