SMC Networks 7724M/VSW - annexe 1, Manual

Page: 86 / 387

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 85
To enable Interleave process, use the following command.
Command Mode Description
lre PORTS channel slow Bridge Enables Interleave process.
The default is Interleave enabled as “ slow ”.
The following is an example of displaying Interleave.
SWITCH(bridge)# show lre interleave 1-5
------------------------------------------
Port Status Channel Inter-Delay
ADM/OPR UP/DOWN
------------------------------------------
1 Up/Down Slow 2/ 2
2 Up/Down Slow 2/ 2
3 Up/Down Slow 2/ 2
4 Up/Down Slow 2/ 2
5 Up/Down Slow 2/ 2
SWITCH(bridge)#
In addition, you can configure the interval of Interleave process during modulation. This
interval is called Interleave-delay. By configuring Interleave-delay, you can prevent trans-
mission delay caused of waiting data gathered.
To configure Interleave-delay, use the following command.
Command Mode Description
lre PORTS interleave-delay
<1-100>
Configures Interleave-delay
PORTS: VDSL port number
1-100: interleave delay value (default:2 ms)
lre PORTS interleave-delay
<1-100> { up ㅣ down }
Bridge
Configures Interleave-delay with specifying Upstream
or Downstream.
The unit of Interleave-delay is “
㎳
” and the default is “2ms”.
In switch, all VDSL ports are contained in one Line-config-profile. For the ports contained
as the member port of Line-config-profile, it is not possible to change Interleave-delay or
SNR margin.
To change it independently, erase the member of Line-config-profile first refer to 5.3.4.1
Line config profile . If you try to configure interleave-delay of the port which is contained as
Line-config-profile member, the error message will be displayed.
i
i
!