SMC Networks 7724M/VSW - annexe 1, Manual

Page: 91 / 387

CLI Management Guide
TigerAccess™ EE
90 SMC7824M/VSW
To display SNR margin, use the following command.
Command Mode Description
show lre snr [ PORTS ] Enable/Global/Bridge Shows the configuration of SNR margin.
The following is an example of configuring SNR margin of port 3 as
“
10
㏈”
.
SWITCH(bridge)# lre 3 snr-target-margin 10 down
SWITCH(bridge)# show lre snr 1-5
-----------------------------------------------------
Port Status Config SNR Target SNR Minimum
ADM/OPR Margin Margin
UP/DOWN UP/DOWN
-----------------------------------------------------
1 Up/Down 6/ 6 5/ 5
2 Up/Down 6/ 6 5/ 5
3 Up/Down 6/ 10 5/ 5
4 Up/Down 6/ 6 5/ 5
5 Up/Down 6/ 6 5/ 5
SWITCH(bridge)#
5.3.2.12 Bitloading Per Tone
The bitloading per tone command is used to fetch the table that shows bit loading, SNR,
attenuation, FEQ fine coeff, noise margin, and so on.
To display the table of each parameter in the range of tone, use the following command.
Command Mode Description
show lre pertoneinfo PORT { rx-bit-ne ㅣ tx-bit-ne
| snr-ne | noise-margin-ne | atten-ne | feq-ne |
tx-pwr-ne | tx-gi-ne | qln-ne | coarse-feq-ne }
<0-4095> <0-4095> [ graph <1-4095>]
Enable
Global
Bridge
Shows the table of each parameter (bit-
loading, SNR, FEQ fine coeff, noie-
margin and so on) in the range of tone.
0-4095: start/ stop tone index
To display the table of each parameter in the range of tone, use the following command.
Command Mode Description
show lre pertoneinfo PORT
{ block | hlog-ne | hlin-ne | hlin-
scale-ne <0-511> <0-511>
Enable
Global
Bridge
Shows the table of each parameter (bitloading, SNR,
FEQ fine coeff, noie-margin and so on) in the range of
tone.
0-511: start/ stop tone index