SMC Networks 7724M/VSW - annexe 1, Manual

Page: 276 / 387

Management Guide CLI
TigerAccess™ EE
SMC7824M/VSW 275
You can create the MSTP regions without limit on the network. But the instance id num-
bers of each region should not be over 64.
To delete the configuration ID setting, use the following command.
Command Mode Description
no name Deletes the name of MSTP region
no instance <1-64> vlan VLANS
Deletes part of vlan-mapping, select the instance ID
number and vlan id to remove from the specified in-
stance
1-64: instance ID number
VLANS: VLAN ID (1-4094)
no revision
MST-config
Deletes the configured revision number.
After configuring the configuration ID in the switch, you should apply the configuration to
the switch. After changing or deleting the configuration, you must apply it to the switch. If
not, it does not being reflected into the switch.
To apply the configuration to the system, use the following command.
Command Mode Description
apply MST-config Apllies the configuration of the region to the system.
After deleting the configured configuration ID, apply it to the system using the above
command.
To display the current and edited configuration on MSTP Configuation mode, use the fol-
lowing command.
Command Mode Description
show current
Shows the current configuration as it is used to run
MSTP
show pending
Shows the edited configuration of MSTP.
show
MSTP
Shows all configurations of MSTP
For example, after setting the configuration ID, if you apply it to the switch with the apply
command, you can check the configuration ID with the show current command.
However, if the user did not use the apply command to apply the configurations to the
switch, the configuration could be checked with the show pending command.
i
i