20/11/2020
71/88
E_MH_Installation_instructions_Skylux_Climax
Ridge for saddle roof
ASSEMBLY
Install the hinge profiles (S1 or S2) to the bottom wall profiles (MB) (1). Depending on the slope angle (2), you may
have to cut off the top part at the end of the hinge to ensure the hinge profile is not hindered by the ridge support
bracket. With a thermal bridge Climax saddle roof, the seal (C11CX) must be installed at both sides (3) between the
wall profile and the hinge profile.
HM + 17
Install the ridge support bracket (NCZ) to the wall.
Check whether the foundation and the walls on which
the structure is to be anchored have a sufficient
load-bearing capacity. The installer is responsible for
the assessment of the appropriate fixing material
for the load and basis on which the structure is to be
fixed. Please contact your fixing material supplier or
specialised engineering consultants in case of doubts.
Slide the assembled ridge profile on to the ridge
support bracket (NCZ) and anchor these using 2 fixing
sets (BMR). Support the ridge profile until the roof has
been fully installed.
3
3
3
3
’
1
1
2
2
’
C11CX
C11CX
