20/11/2020
69/88
E_MH_Installation_instructions_Skylux_Climax
Specific instruction tips for the
saddle roof
Climax system
Ridge for saddle roof
PREPARATION
The ridge of the saddle roof must be attached to at least one wall. Check all dimensions. These can be found in
pages 12 and 13 of this manual. The assembly of the ridge profiles is identical for a thermal and a non-thermal
saddle roof. The ridge can be created using two sets of wall profiles (MB-MT-Y16P) that are assembled back-to-
back using adaptor profiles (Y10). The number of thermal bridges (Y16P) between the bottom wall profile (MB) and
the top wall profile (MT) depends on the glazing thickness and the roof pitch (see the table on page 14).
Cut 5 mm from the bottom wall profiles for the ridge support bracket (NCZ). Connect the wall profiles at the
bottom and at the top using the adaptor profiles (Y10).
5 mm
16 mm
5 mm
MT
MT
Y10
Y10
Y16P
Y16P
MB
MB
MT
C1CX
NCZ
MT
Y10
C1CX
Y16P
Y16P
C11CX
C11CX
S1/S2
S1/S2
Y10
MB
MB
