SKS Sweden Bonfiglioli Vectron ACTIVE CUBE ACU 201 Series, Operating Instructions Manual, Page: 97 / 260

04/08
Operating Instructions ACU
95
SETUP Selection
796 Function
33 - Calc. and para ident.,
DS3
Further motor data are measured, dependent pa-
rameters are calculated and the parameter values
are saved in data set 3.
34 - Calc. and para ident.,
DS4
Further motor data are measured, dependent pa-
rameters are calculated and the parameter values
are saved in data set 4.
110 - Complete Setup w/o
Para-Ident., DS0
The auto set-up routine is performed in data set 0
and the parameter values are stored in all of the
four data sets identically. Extended motor data are
not measured.
111 - Complete Setup w/o
Para-Ident., DS1
The parameter values of the auto set-up are stored
in data set 1. Extended motor data are not meas-
ured.
112 - Complete Setup w/o
Para-Ident., DS2
The parameter values of the auto set-up are stored
in data set 2. Extended motor data are not meas-
ured.
113 - Complete Setup w/o
Para-Ident., DS3
The parameter values of the auto set-up are stored
in data set 3. Extended motor data are not meas-
ured.
114 - Complete Setup w/o
Para-Ident., DS4
The parameter values of the auto set-up are stored
in data set 4. Extended motor data are not meas-
ured.
The individual steps of the auto set-up routine can be monitored and checked via
parameter
SETUP Status
797. The setup routine via the communication interface
continuously updates the status parameter which can be read out via the interface.
Status messages
Message Meaning
OK Auto set-up routine has been carried out.
PC Phase 1 The plausibility check of the motor data is active.
PC Phase 2 The calculation of dependent parameters is active.
STO
The parameter identification demands the controller release
on digital input S1IND/STOA and S7IND/STOB.
Parameter identifica-
tion
The rated motor values are checked by the parameter iden-
tification feature.
Setup already active The setup routine via the control unit is being carried out.
No enabling signal
The parameter identification demands the controller release
on digital input S1IND/STOA and S7IND/STOB.
Error Error during the auto set-up routine.
Warning phase asym-
metry
The parameter identification feature diagnosed an unbal-
ance during the measurements in the three motor phases.
Operating Instructions ACU 95 09/08