20.Press the electronics module cover lid in the inside fitting carefully out
of its bracket and fold back horizontally. Make sure that the electronics
are not subject to mechanical load and are not damaged in any other
way.
21. Carefully remove the upper battery (10) from the holder. Use clean
gloves free of fat or grease to handle batteries.
22. Insert the supplied screws (9) through drill holes in the inside fitting (8)
from inside the door and fasten to the spacing bolts (7) on the outer fit-
ting by hand, using about 5-7 Nm. Ensure that you do not squash the 2-
pole cable when doing so.
23. Insert the upper battery (10) with the positive terminals facing away
from the door into the brackets; in doing so, insert the batteries under
the black retaining collar first. Use clean gloves free of fat or grease to
handle batteries.
24.Carefully lock the electronics cover lid back into place.
25. Check that the outer handle (3) can turn easily; if it does not, there may
be a problem with the mortise lock (6) or the handle may have been fit-
ted incorrectly. In case of doubt, disassemble components and start
again from Step 10.
26.Push inside handle (11) onto the inner fitting (8) fastening flange until it
will go no further.
27. Tighten the hexagon screw (12) on the inside handle (11) firmly by hand,
using about 5-7 Nm.
28.Push the cylinder through the designated hole in the fitting from the
outside. In doing so, ensure that the cam is at the six o'clock position
and that the 3-pole cable does not get caught or buckled.
29.Fasten the cylinder with the fastening screw by hand (about 5-7 Nm)
(note that cylinder and fastening screw are not part of the supply).
30.Push inlay (14) onto the inside handle (11). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
31. Push the cover (13) over the inside handle (11).
32. Carefully push the inlay (14) through the opening in the inside cover (13).
33. Push the cover (13) onto the inside fitting (8), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
34.Click the inlay (14) carefully into the cover (13).
35.Push the cover (2) over the outside handle (3).
36.Carefully push the inlay (1) through the opening in the outside cover (2).
SmartHandle
SmartIntego
(Manual)
8. Installation (manual)
68 / 160
Summary of Contents for SI:SmartHandle Series
