SimonsVoss SI:SmartHandle Series, Manual

Page: 73 / 160

8 Inside handle
9 Headless screw for inside handle
10 Inside cover
11 Inlay
X1 Sleeves
X2 Screws
SKG components
A Adapter plate for inside fitting
B Installation key for outer fitting
C Adapter plate for outer fitting
D Spacer plate for outer fitting
8.5.4.2 Step 0: Preparing drill holes
NOTE
The mortise lock must be removed from the lock before drilling to avoid
damaging it. The door lock can be re-fitted to the door once drilling is com-
plete.
NOTE
The mortise lock must feature a drill hole as specified in DIN 18251, other-
wise SI:SmartHandle cannot be installed. It is assumed that the mortise
lock has been fitted according to instructions.
1. Align drilling template precisely.
9 The cut for the spindle must be positioned exactly over the retainer
opening in the door lock.
9 The template must be positioned completely parallel to the door
edge. The dimension lines act as a reference.
9 The centre hole must fit precisely over the hole in the lock.
2. Use a suitable pen or pencil to mark the required drill holes.
3. Place drilling template back on again to check the marks are correct.
4. Dismount door lock from door.
5. Drill top hole with a suitable 8-mm drill bit.
6. Drill middle hole with a suitable 8-mm drill bit.
7. Drill lower hole with a suitable 13-mm drill bit. It is recommended to pre-
drill the hole with a 8 mm bit first.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
73 / 160