SimonsVoss SI:SmartHandle Series, Manual, Page: 81 / 160

C Bolt sensor
D Installation tool for bolt sensor
E anti-twist mechanism
8.6.4.2 Step 0: Preparing drill holes
NOTE
Please remove the lock from the door before drilling to prevent it from be-
coming damaged! The lock can be reinstalled in the door once you have
completed drilling.
1. Align drilling template precisely.
9 The cut for the spindle must be positioned exactly over the retainer
opening in the door lock.
9 The template must be positioned completely parallel to the door
edge. The dimension lines act as a reference.
2. Use a suitable pen or pencil to mark the two drill holes.
3. Place drilling template back on again to check the marks are correct.
4. Drill top hole with a suitable 8 mm drill bit.
5. Drill lower hole with a suitable 13 mm drill bit. It is recommended to pre-
drill the hole with a 8 mm bit first.
8.6.4.3 Step 1: Installing the fastening screw sensor
NOTE
The fastening screw sensor may not be in locked final position during in-
stallation. The fastening screw sensor must be in the displayed "INSTALL-
ATION" position; otherwise ("LOCKED") the outer ring must be pushed
back carefully so that the spring mechanism is tensioned.
INSTALLATION LOCKED
1. Insert the end of the fastening screw sensor cable (B) (with plug) into
the sensor screw drill hole.
2. Use a suitable tool (e.g. tweezers) to guide the plug out of the profile
cylinder opening on the inner side.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
81 / 160