SimonsVoss SI:SmartHandle Series, Manual, Page: 155 / 160

16.8 Restore storage mode for RRMO
1. Disconnect the internal fitting 3-pole cable from the outer fitting 3-pole
cable. If necessary, also disconnect the LockNode cable from the inner
side fitting.
2. Hold the internal and outer fittings firmly while pulling them away from
one another horizontally.
Fitted to the door:
NOTE
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately. In such a case, push the inlay
through the opening in the cover and remove the cover. The inlay remains
on the handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
16.9 Restore storage mode for RMO
1. Disconnect the internal fitting 3-pole cable from the outer fitting 3-pole
cable. If necessary, also disconnect the LockNode cable from the inner
side fitting.
2. Hold the internal and outer fittings firmly while pulling them away from
one another horizontally.
Fitted to the door:
NOTE
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately. In such a case, push the inlay
through the opening in the cover and remove the cover. The inlay remains
on the handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
SmartHandle SmartIntego (Manual)
16. Disassembly
155 / 160