SimonsVoss SI:SmartHandle Series, Manual

Page: 71 / 160

8.5.2 Tools required
The following tools are required for installation and are not included in the
supplied package:

Allen key (3 mm) to fit handle.

Cross-tIPscrewdriver type PH2 to fit mounting screw (battery
screwdriver recommended).

19 mm spanner for installing the handle fastener piece.

Drill

8 mm drill bit

Sharp object (for example pin needle)
8.5.3 Installation instructions

Batteries are already installed when the product is delivered!

When installing the electronic SI:SmartHandle, ensure that there are no
sources of low-frequency interference in the surrounding area.

SI:SmartHandle must be fitted, so that it is flush with the door. You
must install the product as specified to ensure that it is structurally
stable and will have a long service life.

You must not strike parts of SI:SmartHandle during installation.

The two inlays in the cover are locked into position with a clip
mechanism. These may only be removed using the SimonsVoss
installation tool.

No water or moisture must penetrate the door or reach the inner side.
Always use the WP version for moisture.

Programme SI:SmartHandle before installing.

SI:SmartHandle may be difficult to fit in mortise locks with a retaining
nut. You must not alter the retaining nut in any way, using a file, for
example; otherwise, the handle's guide piece will no longer fit
accurately.

When installing SmartHandle, you must ensure that the cable does not
get caught or fitted too tightly to the door.

Conventional fastening system: When fitting the handle into position on
the door with the two screws, make sure that the electronics are not
subject to mechanical load and are not damaged in any other way.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
71 / 160