SimonsVoss SI:SmartHandle Series, Manual

Page: 57 / 160

28.Check that the outer handle (3) can turn easily; if it does not, there may
be a problem with the mortise lock (6) or the handle may have been fit-
ted incorrectly. In case of doubt, disassemble components and start
again from Step 10.
29.Push inlay (14) onto the inside handle (11). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
30.Push inside handle (11) onto the inner fitting (8) fastening flange until it
will go no further.
31. Fasten the inside handle hexagon screw (12) firmly by hand.
32. Push the cover (13) over the inside handle (11).
33. Carefully push the inlay (14) through the opening in the inside cover (13).
34.Push the cover (13) onto the inside fitting (8), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
35.Click the inlay (14) carefully into the cover (13).
36.Push the cover (2) over the outside handle (3).
37. Carefully push the inlay (1) through the opening in the outside cover (2).
38.Push the cover (2) onto the outer fitting (4), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
39.Click the inlay (1) carefully into the cover (2).
8.3.5 Conventional fastening system WP
Installation:
1. Optional: Disassemble handles / escutcheons / fittings, etc. that are
mounted to the door.
2. SmartHandle is partly assembled when supplied; see "Disassembly".
3. The inlay cannot be fitted on some handles, such as offset handles,
when they are already installed. Push the inlay onto the outer handle
with the logo facing outwards in such cases. You can do this with most
handles.
4. Optional: In a lock with an 8.5 mm or 10 mm spindle, push the corres-
ponding sleeve (8 mm --> 8.5 mm [not included in the supply package]
or 8 mm --> 10 mm) through the retainer opening in the mortise lock
from the inside.
5. Push the inside fitting (8) spindle through the retainer slot in the door's
mortise lock (6), so that the fitting is flush with the door.
6. Position the inside fitting (8) in such a way that it is parallel to the door.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
57 / 160