SimonsVoss SI:SmartHandle Series, Manual, Page: 58 / 160

7. Mark the drill holes required on the door through the corresponding
holes in the inside fitting (8).
8. Remove inside fitting (8) from the door.
9. Drill the 2 holes with a diameter of 8 mm through the door.
10. Push inlay (1) onto the outer handle (3). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
11. Insert outer handle (3) horizontally into the outer fitting (4), placing it in
the direction that you require, depending on whether it is a DIN left-hand
or DIN right-hand door.
12. Place handle fastener piece (5) into position (see Figures 2 and 3).
13. Hold the outside handle (3) and use the spanner to rotate the fastener
piece (5) about 75° to the right until it fits into position (Figures 4 and
5). If you do not fit it correctly, the handle may come loose again.
14. The inside fitting (8) is mounted onto the inner surface of the door. Push
the inside fitting spindle through the retainer slot in the mortise lock (6)
and push the inside fitting (8) onto the door until it is flush with the door.
15. Insert the lower spacing bolt (7) into the outer fitting (4); the upper spa-
cing bolt (7) is pre-fastened into position in the factory.
16. Push the cable for the outer fitting through the profile cylinder/Swiss
Round/British Oval opening in the mortise lock (6) and ensure that it
doesn't get caught or buckled.
17. Push the outer fitting retainer slot onto the spindle while pushing the
two spacing bolts (7) through the drill holes in the door at the same
time. In doing so, ensure that the inside fitting cable does not get caught
or buckled.
18. Connect the 3-pole cable from the outer fitting to the 3-pole cable from
the inside fitting. This cable can only be inserted in one direction. Do not
pull on the cables while doing so; just carefully secure the plug-in con-
nection into position.
19. The 2-pole cable from the inside fitting can hang freely, but must not
get caught or buckled when the inside cover is fitted. Do not pull on the
cable. The second cable is optionally used to connect the LockNode cir-
cuit board.
20.Press outer and inside fittings together, so that they are both flush
against the door.
21. Press the electronics module cover lid in the inside fitting (8) carefully
out of its bracket and fold back horizontally. Make sure that the elec-
tronics are not subject to mechanical load and are not damaged in any
other way.
22. Carefully remove the upper battery (10) from the holder. Use clean
gloves free of fat or grease to handle batteries.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
58 / 160