SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:+420 533 338 854 l F:+420 533 338 883 l www.signamax.eu
78
1. Network Configuration: Set up the required IP configuration of the Managed Switch.
2. System Service Management: Enable or disable the specified network services.
3. RS232/Telnet/Console Configuration: View the RS-232 serial port setting, specific
Telnet and Console services.
4. Time Server Configuration: Set up the time server’s configuration.
5. Device Community: View the registered SNMP community name list. Add a new
community name or remove an existing community name.
6. Trap Destination: View the registered SNMP trap destination list. Add a new trap
destination or remove an existing trap destination.
7. Trap Configuration: View the Managed Switch trap configuration. Enable or disable a
specific trap.
8. Mal-attempt Log Configuration: Set up the Mal-attempt Log server’s configuration.
4.3.1 Network Configuration
Click the option Network Configuration from the Network Management menu and then
the following screen page appears.
MAC Address: This view-only field shows the unique and permanent MAC address
assigned to the Managed switch. You cannot change the Managed Switch’s MAC address.
Configuration Type: There are two configuration types that users can select from the pull-
down menu; these are "DHCP" and "Manual". When "DHCP" is selected and a DHCP
server is also available on the network, the Managed Switch will automatically get the IP
address from the DHCP server. If "Manual" is selected, users need to specify the IP
address, Subnet Mask and Gateway.
NOTE: This Managed Switch also supports auto-provisioning function that enables DHCP
clients to automatically download the latest Firmware and configuration image from the
server. For information about how to set up a DHCP server, please refer to
APPENDIX B
.
