SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:+420 533 338 854 l F:+420 533 338 883 l www.signamax.eu
41
frame-type arp <source_mac>
<dmac_type> <type> <opcode>
<source_ip><dest_ip><arp_smac_
match> <rarp_dmac_match>
<ip/ethernet_length_check> <ip>
<ethernet>
Configure the ARP frame type settings.
<source_mac>: Specify “Any” to apply ACL
rule to any source MAC addresses. Or, enter
the specific source MAC address.
<dmac_type>: Specify “Any” to apply ACL
rule to any destination MAC addresses. Or,
specify “uc” to apply ACL rule to unicast
traffic; “mc” to apply ACL rule to multicast
traffic; “bc” to apply ACL rule to broadcast
traffic.
<type>: Specify “any”, “arp”, “rarp”, or “other”.
<opcode>: Specify “any” to apply ACL rule to
both reply and request frames; “reply” to
denote reply frames; “request” to denote
request frames.
<source_ip>: This is sender IP filtering
function. Specify “any” to filter frames from
any sender IP addresses. Or, specify either a
host IP address or a network address and
subnet mask.
<dest_ip>: This is target IP filtering function.
Specify “any” to filter frames to any target IP
addresses. Or, specify either a host IP
address or a network address and subnet
mask.
<arp_smac_match>: This is to configure
whether ARP source MAC sent and received
are matched or not. Specify “any” to denote
both a match and not a match; “0” to denote
not a match; “1” to denote a match.
<rarp_dmac_match>: This is to configure
whether RARP destination MAC sent and
received are matched or not. Specify “any” to
denote both a match and not a match; “0” to
denote not a match; “1” to denote a match.
<ip/ethernet_length_check> : Specify “0” to
indicate that HLN (Hardware Address Length)
field in the ARP/RARP frame is not equal to
Ethernet (0x6) and the Protocol Address
Length field is not equal to IPv4 (0x4). Specify
“1” to indicate that HLN (Hardware Address
Length) field in the ARP/RARP frame is equal
to Ethernet (0x6) and the Protocol Address
Length field is equal to IPv4 (0x4). Specify
“Any” to indicate a match and not a match.
<ip>: Specify “0” to indicate that Protocol
Address Space field in ARP/RARP frame is
not equal to IP (0x800). Specify “1” to indicate
that Protocol Address Space is equal to IP
(0x800). Specify “Any” to indicate a match and
not a match.
<ethernet>: Specify “0” to indicate that
Hardware Address Space field in ARP/RARP
frame is not equal to Ethernet (1). Specify “1”
to indicate that Hardware Address Space field
is equal to Ethernet (1). Specify “Any” to
indicate a match and not a match.
