SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:+420 533 338 854 l F:+420 533 338 883 l www.signamax.eu
43
frame-type icmp <dmac_type>
<icmp_type> <icmp_code>
<source_ip><dest_ip> <ip_ttl>
<ip_fragment> <ip_option>
Configure the ICMP frame type settings.
<dmac_type>: Specify “Any” to denote any
destination MAC addresses. Or, specify “uc”
to denote unicast traffic; “mc” to denote
multicast traffic; “bc” to denote broadcast
traffic.
<icmp_type>: This parameter is to show and
filter the ICMP type defined in the type field of
the ICMP header. Specify “any” to filter any
types; specify “0-255” to filter different defined
types.
<icmp_code>: This parameter is to show and
filter the ICMP code defined in the code field
of the ICMP header. Specify “any” to filter any
types; specify “0-255” to filter different defined
codes.
<source_ip>: This is source IP filtering
function. Specify “any” to filter frames from
any sender IP addresses. Or, specify either a
host IP address or a network address and
subnet mask.
<dest_ip>: This is target IP filtering function.
Specify “any” to filter frames to any target IP
addresses. Or, specify either a host IP
address or a network address and subnet
mask.
<ip_ttl>: Specify “0” to indicate that the TTL
field in IPv4 header is 0. If the value in TTL
field is not 0, use “1” to indicate that. You can
also specify “any” to denote the value which is
either zero or not zero.
<ip_fragment>: Specify “0” to indicate that
the fragment field in IPv4 header is 0. If the
value in TTL field is not 0, use “1” to indicate
that. You can also specify “any” to denote the
value which is either 0 or not 0.
<ip_option>: Specify “1” to indicate that the
IPv4 header is bigger than 5 bytes; “0” to
indicate that the IPv4 is 5 bytes. Specify “any”
to denote the value which is either 0 or not 0.
