4 Getting Started
4.4 System Requirements
30
SICAM I/O Unit, 7XV5673, Device Manual
E50417-H1040-C484-A3, Edition 05.2012
Terminals for supply voltage (H), binary inputs; and relay outputs (N, P) on the terminal side:
Conductor cross-section, rigid max.
2.5 mm² (AWG 14)
Conductor cross-section with ferrule
1.5 mm² (AWG 16)
Tightening torque
0.4 Nm to 0.5 Nm (3.5 in-lb to 4.5 in-lb)
Communication Interfaces
RS485 interface (J) on the terminal side:
RS485 cable with plug connector
820 nm fiber-optic interface (J) on the terminal side:
Fiber-optic cable with prepared ST plug (for example
6XV8100)
Ethernet interface (Z) on top:
Patch cable, crossover cable, or a Y cable, when using
the internal Ethernet switches
4.4
System Requirements
To operate SICAM I/O Unit with a PC or notebook, the following system requirements must be met:
•
PC or notebook with Intel Pentium processor (or compatible type); clock frequency min. 800 MHz
•
Operating system: Microsoft Windows XP Professional with Internet Explorer 6.0 (or higher)
•
Minimum 1 GB RAM primary storage
•
VGA display 1024 x 768 with truecolor
•
Mouse and keyboard
4.5
Access Rights
Access Rights for Configuration and Maintenance
Access rights are controlled by setting up passwords during the device configuration. For this purpose, you
have to assign an activation password and a maintenance password. The setting up of passwords is described
in chapter 6.3.3.9.
If parameter changes are to be activated in the device, the activation password is required. If changes are to
be made in the device via the maintenance tab, the maintenance password is required.
DANGER
Danger due Laser radiation! Class 1
Non-observance will lead to death or serious injury.
✧
Do not look into the fiber-optic elements!
NOTE
If you do not set up new passwords, the passwords automatically implemented by default (see chapter 6.3.3.9)
will be valid.
MAN_SICAM_IO-Unit_7XV5673_US.book Page 30 Thursday, May 10, 2012 10:59 AM
