Siemens 7ML1301-1, Instruction Manual, Page: 76 / 99

Page 72 SITRANS LG200 – INSTRUCTION MANUAL 7ML19985KA02
A: P
a
ra
met
e
r List
Appendix A: Alphabetical Parameter
List
NOTE: Parameters described in the following are dependant on probe type.
Default values may change according to probe type. This will assist with
set-up of the SITRANS LG200 with pre-programmed, application specific
defaults.
Users should check all parameters for validity before returning the unit
into operation.
Parameter Name Page Number
20 mA Setpoint (Set 20 mA) (100%* reference point) 65
Default: 120 in, 396.3 gal (User password)
4 mA Setpoint (Set 4 mA) (0%* reference point) 65
Default: 0.0 in, 0 gal (User password)
7ML1305-1 Correction (factory authorized personnel only) 71
Default: 0.0 (Superuser password)
Blocking Distance (BlockDis) 66
Default: 0 cm (User password)
Compensate (Compsate) (factory authorized personnel only) 70
Default: None (Superuser password)
Conversion Factor (Conv Fct) (factory authorized personnel only) 69
Default: 985 (Factory password)
Damping (Damping) 65
Default: 0 sec. (User password)
Volume Units (Vol Units) 62
Default: gallons (User password)
Level Units (LVL Units) 60
Default: inches (User password)
Loop Control (Loop Ctrl) 64
Default: Level ((User password)
Measurement Type (MeasType) 60
Default: Lvl Only (User password)
Derating Function (Lvl only) (factory authorized personnel only)1 70
Dielectric (Dielctrc) 63
Default: 10 - 100 (probe dependent) (User password)
Display Factory Parameters (Disp Fact) 69
Electronics Temperature (Elec Temp) (factory authorized personnel only) 71
Fault Output (Fault) 65
Default: 22 mA (User password)