Chapter
5
Operating instructions
RFID Access Management
38
Operating instructions | SICK
8018582/2015-11-03
Subject to change without notice
Electrical installation
5.3.4
Connecting the additional switching output of the connection module
If you are using the additional switching outputs of the connection module,
use terminals
23
or
24
for the connection.
Fig. 27: Connection of the additional digital switching outputs in the connection module
5.4
Connecting the configuration PC to the network
In general, the configuration PC containing the management software is connected to
the RFID interrogators via a network switch.
Fig. 28: Connecting the configuration PC to the network
Connection via Ethernet switch
Connect the PC to the Ethernet switch.
Direct network connection between the PC and RFID interrogator
A direct network connection between the RFID interrogator and the configuration PC is
required in the following cases:
•
Setting the transmitting power of the RFID interrogators with SOPAS (see
•
Configuring RFID interrogators that are not permanently connected to the configuration
PC.
Fig. 29: Direct connection between the configuration PC and RFID interrogator