6
COMMISSIONING
56
8022161-1B29 / V2-0/2021-04|SICK
T R A N S L A T I O N O F A N O R I G I N A L O P E R A T I N G I N S T R U C T I O N S | Backup Assistance System
Subject to change without notice
NOTE!
The
Undo
and
Redo
icons can be used to correct an action that was performed by
mistake.
▸
Click on the
Set field points
icon.
▸
Click on the border of the outer field at the desired position.
SOPAS inserts a new, green marker square.
▸
Now click on the
Move field points
icon and move the newly added field point as
described.
▸
Click on the
Delete field points
icon.
▸
Click on the green marker square of the field point you want to delete. The color of the
marker square changes to red.
▸
Click again on the field point to be deleted. SOPAS removes the marker square and
instead connects the two nearest marker squares with a new line.
▸
Click on the icon of the active editing function again to finish editing the monitoring
field.
▸
Answer the query of whether the modified geometry should be transmitted to the
2D LiDAR sensor with
Yes.
The modified geometry is transmitted to the 2D sensor. The grip points of the
monitoring field are now no longer visible in the scan range.
•
With
No,
the modified geometries are still available in SOPAS. They can then be
transmitted to the device at a later point in time (see following chapter).
NOTE!
The message is not displayed if you change to a different editing function.
The grip points remain visible and can be edited as described.
Inserting
additional field points
Deleting
field points
Ending editing mode