Shihlin electric SDE Series, Manual

Page: 105 / 242

97
No Abbr. Function description
Control
mode
Setting
range
Unit
PC28 MO1 Analog monitor ch1 offset
Used to set the output offset voltage of analog monitor MON 1.
Pt, Pr
S,T
-999
~+999
mV
PC29 MO2 Analog monitor ch2 offset
Used to set the output offset voltage of analog monitor MON 2.
Pt, Pr
S,T
-999
~+999
mV
PC30 MOG1 Analog monitor ch1 output proportion
Used to set output ratio of monitor signal to be viewed.
Pt, Pr
S,T
1
~100
%
PC31 MOG2 Analog monitor ch2 output proportion Pt, Pr
S,T
1
~100
%
PC32 CMX2 Electronic gear numerator 2
Refer to the description of PA06.
Pt, Pr 1
~2
26
-
PC33 CMX3 Electronic gear numerator 3 Pt, Pr 1
~2
26
-
PC34 CMX4 Electronic gear numerator 4 Pt, Pr 1
~2
26
-
PC35 VCL VC input voltage limit
Used to limit the range of speed analog command(VC).
“0”
denotes no limit. A
“5000” setting of PC35 as an example
：
even
the actual analog command is 10V, the drive would recognize
that the maximum input voltage is only 5V.
S,T 0
~20000
mV
PC36 VMFT VC/VLA linear voltage filter time constant
This is a moving filter. It is unlike the PB18 which is a low-pass
filter. The difference between them is that PC36 affords both
start and stop smoothing effect, but PB18 affords only stop
smoothing effect. If speed mode is applied with the superior
controller command to perform position loop control, the PB18
is recommended. If pure speed or torque mode is applied, use
PC36 to obtain a better smoothing effect.
S,T 0
~40
0.1ms
PC37 DTA9 AL09 occurrence delay time
The delay time of t AL09 occurrence detection after power on.
The
“0” setting value means this delay disabled.
Pt, Pr
S,T
0
~20000
ms