Sharp SF-2040, Service Manual, Page: 54 / 131

* Be sure to store any parts with care that are not used because
they are necessary for changing the papersize.
Before performing the following procedure, be sure to
remove the power plug of the copier main unit.
1. To remove the stopper for the packaging
cassette unit.
Remove the stopper for the packaging the paper pressure plate in the
cassette unit.
When using default setting:
★
Skip to step 7 and perform the following steps.
Initial set paper size is A3 or 11 x 17.
When using after changing paper size:
2. To change the size setting of side plate F and
side plate R.
Insert side plate F and side plate R into the cassette main unit and
align them on the marking for the desiredsize, and secure the side
plates with fixing screws (2 pcs. each).
3. To change the size position of the rear end plate.
Remove the rear end plate from its rear storage place, and insert this
into the cassette main unit for the desired size.
When you switch the size to A5 or 8 1
⁄
2
x 5 1
⁄
2
, fix this plate to the
rotary plate by using the screw that is attached to the rear end
plate.
4. To set the size detection spacer.
Reposition the size detection spacer for the desired paper size.
A3 · A4 · A4R · A5 · B4
Cassette size label
two sheets each
AB system
8½ x 11 · 8½ x 11R
8½ x 14 · 8½ x 5½
11 x 17
Inch system
two sheets each
Stopper for packaging
Side plate R
Fixing screw
Fixing screw
Side plate F
Rear end plate
Size detection spacer
A4
A4R
A5
B4
B5
A3
B5R
Setting diagram for size detection spacer
(AB system)
EXTRA
8 1/2 x 11
11 x 17
8 1/2 x 14
8 1/2 x 11R
8 1/2 x 5 1/2
(Inch system)
EXTRA
5 – 26