Sharp AR-650, Service Handbook

Page: 40 / 200

1 - 33 ADJUSTMENT
1.2.6 How to register/change ID codes (Access control mode)
When ID codes are registered, copies made will be classified according to each ID code. The copier
will not start unless one of the ID codes registered is keyed in.
<Preparation to enter the access control mode>
[6] [0] [0] [START] [PWR OFF]
[SET]
or
[INT]
(Memorizing)
[0] [8]
[PWR]
[1]
(Enabled)
R
Procedure to register ID codes:
C1
[C] (To correct)
[C]
R [8] [START]
[PWR]
[E/S]
(Memorizing)
[E/S]
(Memorizing)
ID code Counter value (7 digits)
“0525 ”
displayed
“– – – –”
displayed
Input an ID code
of four figures
ex: 0525
C1 [HELP] [START] Warm-up
“– – – –”
displayed
Input next ID
Up to 120 ID codes
can be registered
Procedure to change ID codes:
C2
[C]
(To cancel)
[START] Warm up
[HELP]
(To skip)
[COPY]
[START] Warm-up
[START] Warm up
C2 R [8] [START]
[PWR]
[E/S]
(Memorizing)
[E/S]
(Memorizing)
[START] Warm-up
[E/S] [START] Warm-up
“0525 1960”
displayed
“– – – –”
displayed
“– – – –”
displayed
(Add ID)
Next ID code
displayed
[“0525 1960”]
Key in XXXXXX
Correct the
number of copies Input the
number
of copies
(Input ID)