Scout Boats 222 Abaco, Owner'S Manual

Page: 92 / 116

92
13.4 Bilge
To keep the bilge clean and fresh, it is recommended that
you use a commercial bilge cleaner on a regular basis. Fol-
low the directions carefully. All exposed pumps and metal
components in the bilge should be sprayed periodically with
a protector to reduce the corrosive effects of the high humid-
ity always present in these areas.
Periodically check the bilge pumps and alarms for proper op-
eration and clean debris from the strainers and float switches.
Inspect all hoses, clamps and thru-hulls for leaks and tight-
ness on a regular basis and operate all thru hull valves at least
once a month to keep them operating properly.
Frequently test the automatic switches for the bilge pumps
and alarms for proper operation. This is accomplished by
removing the pump from the base and raising the float switch
until the pump is activated. You can also use a garden hose to
flood the bilge until the water level is high enough to activate
the pump.
13.5 Drainage System
It is essential that the following items be done periodically to
maintain proper drainage of your boat:
• Clean the cockpit drains with a hose to remove debris
that can block water drainage.
• Clean the hardtop, T-top leg or leaning post drain holes.
This is especially important just before winter lay-up.
• Flush all gravity drains with freshwater to keep them clean
and free flowing.
• Operate the thru-hull valves once a month and service as
required.
Note: All drains and pumps must be properly winter-
ized before winter lay-up.