User Manual SM6026
12
inserting the U-disk on the MEAS interface.
19) LCD
:
800*480 colorful TFT LCD displays measurement results and
conditions.
20) POWER
:
Power switch
21) [DC BIAS]
:
[DC BIAS] is used to permit or forbid the output of 0-100mA/10V
DC bias source. Press this key, it will be lighted which means DC
bias output is permitted. Press this key once more, it will be off
which means DC bias output is prohibited. The key is useless in
some pages where the DC BIAS cannot be added.
22) [KEYLOCK]
:
Press [KEYLOCK], it will be lighted, which means the function of
current panel is locked. Press it again, it will be off, which means
discharging the lock status. If the password function is ON, it
means correct password is necessary when discharging the
key-lock, or the key cannot be unlocked. When the instrument is
controlled by RS232, [KEYLOCK] will be lighted. Press
[KEYLOCK] again, it will be off, which means returning to the local
discharging lock status.
23) HOST interface
:
Connect U flash disk so as to save or load the file.
24) [DC SOURCE]
:
This key is reserved for future use of extension.
2.2 Rear Panel Controls
Figure 2-2 shows the rear panel of SM6026
1) LAN interface
:
LAN interface is used to realize the control and the communication of
network system.
2) USB DEVICE interface
:
The tester can communicate with PC through the USB DEVICE
interface.
3) RS232 interface
:
Series communication interface can realize the communication with
PC.
4) HANDLER interface
:
Handler interface is used to realize the sorting output of test results.
5) IEEE-488 interface
:
The tester can communicate with PC through GPIB interface.
6) Ground terminal
:
The ground terminal is connected with instrument casing, being
available for protecting or shielding ground connection.
