SATO S84NX, Operator'S Manual, Page: 271 / 588

271
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
• The value of [Pitch], [Offset] and [Darkness Adjust] set in the [Factory] menu will be
reflected to the same item settings in the [Configure List] menu, [Configure QR] menu,
[Paper Sensor] menu and [Head Check] menu.
• The settings in [Pitch], [Offset], and [Darkness Adjust] are linked and are changed with
the settings in the [Printing] > [Advanced] > [Adjustments] menu.
[Configure List]
Print the product's settings information.
1. Check and set the items as listed on the [Configure List] menu.
2. Press the
button to start the test print. Press the button again to pause the
print.
To stop the test print, first pause the print and then press the button.
The setting items are as follows:
Label Width
Shows the necessary media width of the test print.
The necessary media width is 50.8 mm (2") for [Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution S84NX S86NX
203 dpi
(1 dot = 0.125 mm
(0.0049"))
400 to 1600 dots 400 to 1600 dots
305 dpi
(1 dot = 0.083 mm
(0.0033"))
600 to 2400 dots 600 to 2400 dots
609 dpi
(1 dot = 0.042 mm
(0.0017"))
1200 to 4800 dots -
Pitch
Set the print position in the vertical direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows: