SATO S84NX, Operator'S Manual, Page: 236 / 588

[RFID] (S84NX Only)
236
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
[RFID Tag Model]
Register, edit, read, and delete RFID tag models. The RFID tag model is a registered combination of
the optimal antenna position, writing/reading power, and tag offset value for each type of RFID tag.
You can register a maximum of 10 RFID tag models.
The setting items are as follows:
[Load]
Read a registered RFID tag model and apply the settings to the product.
You can use this if more than one RFID tag model has been registered.
Select the RFID tag model and press the button to read, and then press the button
in the confirmation message.
The name of the RFID tag model that was read appears on the right side of [Load] on the [RFID Tag
Model] menu.
[Edit]
Register a new RFID tag model or edit registered RFID tag models.
To edit registered RFID tag models, read the targeted RFID tag model in advance in the [Load] menu.
For information needed for these settings, refer to the Inlay Configuration Guide. To view the Inlay
Configuration Guide, access the following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or
reseller.
The setting items are as follows:
Antenna Position
Write Power
Read Power
Tag Offset
Pitch Size
Set the length of the RFID tag.
The setting range varies depending on the print resolution of the product.
The setting range of the RFID tag length is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) 8 to 1920 dots
305 dpi (1 dot = 0.083 mm (0.0033")) 12 to 2880 dots
609 dpi (1 dot = 0.042 mm (0.0017")) 24 to 5760 dots