The figure below shows device type setup of detector/module:
Fig 4- 23 Device type setup
For detectors, the Device Type and Manufacturing Type are generally the same. For
modules, the Device Type and Manufacturing Type are usually different, except for the six
special modules of manual control button, manual call point, fire hydrant call point, sounder
strobe, sounder and strobe whose Device Type and Manufacturing Type are kept the same as
detectors.
Check Annex 1 for Device types provided by this system. If any type not involved which is
required by the customer, the “Add device type” function is available to add up new customized
type.
The Output Mode of modules is set as follows:
Fig 4- 24 Output module setup
The Output Mode refers to the control mode of an output type module when transmitting
signal to its following device. Thus, this option is ineffective to detectors or input type module.
When Pulse is chosen, the output driver signal of the module will cut off after 5-10s. When
Constant is chosen, the driver signal exists continuously.
Zonal setup of detector/module is shown below:
