4.4
Operation
The sub-menus under this category show as below:
Fig 4- 48 Sub-menus of Operation
4.4.1 Mute
4.4.2 Reset
4.4.3 System test
The operation of the above three functions are same with using the functional buttons on
the front panel. Refer to the section of “Panel functions”.
4.4.4 H/S control
Same function with the button of “H/S CTRL”.
4.4.5 Linkage auto/manual
4.4.6 Disable/enable manual control
The above 2 functions are the same with operating the buttons on the front panel. When
enabled, a “√” shows in front of each item.
4.4.7 Sounder auto/manual
When auto is set, a “√” shows in front of the item, and the sounder will start automatically
when a fire is reported. Click this item to switch the state. If several hosts are networked, this
change of the sounder will apply to all hosts in the network with the same state as host 1; if this
change takes place on a local host, it only change itself.
4.4.8 Re-coding check
This check aims to checking out the repeated address number of devices in the loop.