Samsung Ubigate iBG2016, Configuration Manual

Page: 641 / 744

Ubigate iBG2016 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
587
Session Target
Session target is the network address of remote Ubigate iBG2016, which is a
call intended to transmit. Set up in VoIP dial-peer with ‘
session target ’
command. Destination-pattern is telephone number of telephone attempting to
connect in outbound dial-peer. Session target displays the path of the desired
voice device and connected remote Ubigate iBG2016.
Figure 33.8 illustrates the relationship between the destination pattern and the
session target, as shown from the perspective of the originating router.
Figure 8.8 Relationship Between Destination Pattern and Session Target
Session target is used for inbound matching. When Voip incoming does not
match due to number condition, try matching the set session target and the ip
address.
Voip-peer
Voip-peer has protocol type and ip-address. To designate a network-specific
address to receive calls from a VoIP dial peer in addition to use
session target
ip-address command, use the session target name command in dial-peer
configuration mode. The type of voip-peer should be consistent with the
session protocol type of dial-peer. Sip-server, gatekeeper can not be
configured in voip-peer. Voip-peer could be used in not only dial-peer but also
gatekeep, sip-server, call-server, mwi-server or registrat-server.
Following is the example of configuration.
voip-peer voippeer1 sip
ip-address ipv4:10.254.139.56
iBG2016 B
IP Network
iBG2016 A
PBX
Source Destination
579… 389…
Ethernet port Voioe port
VoIP dial peer
session target
VoIP dial peer
destination target