Samsung Ubigate iBG2016, Configuration Manual

Page: 597 / 744

Ubigate iBG2016 Configuration Guide/Ed.00
© SAMSUNG Electronics Co., Ltd.
543
Address Signaling
Is in compliance with ITU-T Q.316~Q.326 recommendation.
Signals Frequencies(Hz) Signals Frequencies(Hz)
KP(start-of-pulsing) 1100 + 1700 Digit 8 900 + 1500
Digit 1 700 + 900 Digit 9 1100 + 1500
Digit 2 700 + 1100 Digit 0 1300 + 1500
Digit 3 900 + 1100 SP(end-of-pulsing) 1500 + 1700
Digit 4 700 + 1300 spare 700 + 1700
Digit 5 900 + 1300 spare 900 + 1700
Digit 6 1100 + 1300 spare 1300 + 1700
Digit 7 700 + 1500 - -
Configure T1-CAS E&M signaling
Step Command Purpose
1 configure terminal Enter the global configuration mode.
2 module t1 slot/sub-
slot/port
Enter the module configuration mode.
3 cas-ds0-group ds0-
group-no
Enter the ds0-group number to create in this E1
trunk.
4 exit Exits the module configuration mode.
5 voice-port slot/sub-
slot/port:ds0-group-no
To set up the attribute values of created ds0-group,
enter voice-port configuration mode.
if ds0-group was created normally, there is no error
in this CLI command.
6 shutdown Shuts down the voice port to manipulate ‘timeslots’
and ‘signal cas’ command.
7 timeslots timeslot-list timeslots-Specifies the single time slot number,
single range of numbers, or multiple ranges of
numbers separated by commas. For T1, allowable
values are from 1 to 24.
Examples are as follows:
-2, 3-5
-1, 7, 9
-1-12