Samsung Ubigate iBG2016, Configuration Manual

Page: 542 / 744

CHAPTER 5. Analog Voice Port
488
© SAMSUNG Electronics Co., Ltd.
How to Configure Analog DID
To set up each parameter of basic analog voice port, follow the next procedures.
y
Configuration Steps
−
configure terminal
−
voice-port
−
dial-peer voice pots
−
exit
y
Detailed Steps
Step Command Purpose
1 configure terminal
Example)
# configure terminal
Enters global configuration mode.
2 voice-port slot/subslot/port Enter voice port Configuration Mode
slot - Specifies the number of the router slot
where the voice module in installed
subslot - Specifies the number of subslot in
the slot
port - Indicates the voice port
3 shutdown Change status of voice port to shutdown
4 signal did {immediate| wink-
start| delay-dial}
This command enables Direct Inward Dialing
on the voice port
immediate - if the voice port must use the
immediate start protocol
wink-start - if the voice port must use the
wink-start protocol
delay-dial - if the voice port must use the
delay start protocol
5 locale locale Selects the two-letter locale for the voice call
progress tones and other locale-specific
parameters to be used on this voice port
The Default is us
ex) locale us